Char-Lynn (Danfoss) Hydraulic Motors 109-1108-006

Series：4000 – Standard；
Seal Type：Standard；
Shaft Type：Taper；
Displacement：7.95 in³/r；
Mounting Type：4-Bolt Flange – 4 in Pilot – SAE B；
Overall Width：4.72 in；
Overall Height：4.72 in；
Overall Length：11.36 in；
Actual Port Type：1.0625-12 UN-2B SAE O-Ring Ports – Staggered Ports；
Port Orientation：Staggered Ports；
Output Shaft Size：1-5/8 in Tapered – Straight Key – Slotted Hex Nut；
Port Configuration：1.0625-12 UN-2B SAE O-Ring Ports – Staggered Ports；
Actual Output Shaft：Taper；
Continuous Flow Rate：95 L/min；
Drain Connection Size：.4375-20 Unf-2b O-ring Port Size -4 With Check Valve；
Intermittent Pressure：310 bar；
Actual Mounting Flange：4-Bolt Flange – Sae B – With 4 In. Pilot Dia.；
Maximum RPM-Continuous：459 rpm；
Replacement Drive Valve：006 Design – 8510-000 – 1 Required；
Replacement Plate Valve：006 Design – 8504-000 – 1 Required；
Replacement Balance Ring：006 Design -21316-000 1 Required；
Replacement Rear Housing：006 Design – 23382-003 – 1 Required；
Max Operating Temperature：180 °F；
Replacement Buna Seal Kit：006 Design – Rear Seal Kit 61234-000, 006 Design – Shaft Seal Kit 61281-000 – 1 Required Each；
Replacement Viton Seal Kit：006 Design – 61248-000 – 1 Required；
Replacement Mounting Flange：006 Design – 23171-002 – 1 Required；
Max Continuous Oil Viscosity：70 Saybold universal second；
Operation Rating Description：Continuous Rating – Motor May Be Run Continuously At These Ratings. / Intermittent Operation – 10 Percent Of Every Minute / Peak Operation – 1 Percent Of Every Minute；
Max System Operating Temperature：-34°C to 82 °C；
Replacement Valve Sold Separately：006 Design – 8500-000 – 1 Required；
Rplc Output Shaft And Bearing Kit：006 Design – 23310-002 – 1 Required；
Replacement Long Cap Screw Cap End：006 Design – 16292-100 – 8 Required；
Replacement Drive – Sold Separately：006 Design – 21372-002 – 1 Required；
Replacement Housing Bearing Side Fnt：006 Design – 23170-002 – 1 Required；
Replacement Geroler – Sold Separately：006 Design – 8464-002 – 1 Required；